Milltronics PL-551 Technical Information download pdf (Page 255)

100

101

SECTION FOUR - PREPARATORY FUNCTIONS (G CODES)

Step 5. The above displaced path is what the system will trace if the part is run.

However, a problem has become apparent from the rough sketch.

Note that the lower left-hand corner will be left uncut because the tool going

from (1) to (2) will leave a small notch of uncut material. A similar case is

obvious in the tool path from (10) to (11). There again the corner will be left

uncut.

The solution is to rearrange the start and end points so that the corner is properly

cut.

241

1 2 ... 250 251 252 253 254 255 256 257 258 259 260 ... 440 441

Comments to this Manuals

No comments

Milltronics PL-551 Technical Information Page 255

Comments to this Manuals

Related products and manuals for Unknown Milltronics PL-551